Join us at SMM Exhibition 2024 in Hamburg from 3th to 6st of september

Hawke Rectangular MCT Seals

For welding

HMX

Type HMX (For Marine Applications), thickness 10mm without Flange. These types of frames are to be welded to the bulk or deck following the installation instructions of Hawke Transit System´s catalogue.

HMOX

Rectangular frame for marine applications with removable end which allows to be installed around existing cables and pipes. Made from 10mm thickness steel.

HMFX

Has a 60mm wide flange and is available in the same materials and finishes as HMX frames. For overall dimensions of HMFX frames add 120mm (allowance for flange) to those given for standard HMX frames.

HMCX

Marine Frames With Round R30 Corners. Very useful for narrow areas in bulkheads and decks.
Our HMCX has multidimensional openings.

HMBX

For sealing cable routes in uninsulated HO rated areas or similar applications. Add 20mm to external dimensions of standard HMX frames to determinate overall width and height.

HMRX TB

For stressed area applications, end fillet pieces with radius corners are added to the HMX frame.

HMEX

A standard HMX frame extended using a welded collar. For use in corrugated bulkheads or to fit the frame above deck level. For overall dimensions of HMEX frames add 20mm to external measurements of Standard HMX frames.

HMX EMC

All standard HTS marine and civil frames are able to be used in EMC systems.

Stainless Steel is highly recommended for EMC applications.

For bolting

HCX

Standard Civil Flanged frame to be bolted or casted to a wall or floor.

HCOX

Frame with removable end which allows the frame to be installed around existing cables and pipes.

HCLX

Civil large frame for sealing services with an overall diameter in excess of 100mm.

HCLOX

This civil frame allows to seal services with a medium radius, greater than 100mm when the cables and pipes are already installed.

HMFBX

Rectangular frame with flange for marine applications. Made from 10mm thickness steel with a 60mm flange.

H-HC Frame

The H-HC frame is manufactured with a 5 cm flange. This flange can be placed centrally in the frame or offset on one side. Available in two sizes, 60 and 120 mm wide (internal).

Made of mild steel or stainless steel.
To be installed (bolted) inside or outside the panels and cabinets.
To be sealed with plugs and standard HAWKE compression system, stayplates and lubricant.
No additional tools required for installation.
Different sizes.

H-DM Frame

Hawke H-DM is a low weight cable sealing solution, frames are made in aluminum to be installed (bolted) inside or outside the panelboards and electrical cabinets, designed for the sealing against external conditions.

Three different sizes.

HMFBX EMC

Rectangular frame with flange for EMC applications. Made from 10mm thickness steel with a 60mm flange.

For casting

HCX