Join us at SMM Exhibition 2024 in Hamburg from 3th to 6st of september
Join us at SMM Exhibition 2024 in Hamburg from 3th to 6st of september
This re-usable compression tool is designed to apply compression to the system before placing the endpacker within the frame.
This makes the operation of installing the compression system much easier than a conventional bolt-type system.
This re-usable tool is designed to extract the compression system without damaging the frame and reducing dismantling time up to 50%. This also means that you can re-use the Hawke compression system.
This re-usable tool is designed to hold the frame in position during the welding process, avoiding deformations due to high temperature.
This re-usable tool is designed to hold the blocks or cables in position during an installation, especially useful in horizontal frames, partial installations or when the amount of cables makes the installation uneasy.
The lubricant remains soft and will not dry out with the passing of time,
It is used in EMC Systems to fill de gap between the cable screen and the EMC HF block after cable sheath has been removed.
Remove the cable sheath with precision and without damaging the cable screen.
Mastic should be applied between the flange of the frame and the structure to ensure a tight seal and avoid possible gaps.
It must be applied between the frame flange and the structure to ensure a tight seal and avoid possible gaps.
Backing plates are designed to be installed on the opposite side of a frame, giving a wall or structure finished appearance.
The mould can be round or rectangular.
The mould can be round or rectangular.
What are you looking for?
Navegation
Contact
